Attach the seal strip to the bottom of the door and cut it to the required length.
Put shower doors back on.
Tighten the hinges that are attached to the wall.
Again using the screwdriver loosen the screw holding the roller and adjust it in the slanted slot it is attached to.
Attach the door handles and any towel bars.
Lift it up inside the top track and bring it back to vertical as you hang the rollers on.
Take this time to clean your screws with vinegar.
Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp.
Replace the shower door and tighten the.
Follow the installation instructions provided as details may vary but the following steps are typical.
Place end caps on the tops of the wall channels.
This is how to repair and put a shower door back on track.
Spray the hinges with some wd 40 to help loosen them up.
Install the outside panel by lifting it up inside the top track and.
Loosen and remove the hinge screws that are attached to the door and remove the whole shower door.
Raise or lower the doors and test the adjustment.
Make slight adjustments and.
Sliding shower doors commonly fall off.
Top rollers adjustment and bottom guide replacement and repair.